2-13
2
2
2
2
2
3
To print, hold the media with the media
press gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
• You do not need to use the media holder for
cutting.
4
Push down the clamp lever.
• Set the media straight.
5
Press the key.
6
Press the key to select "LEAF" .
7
The media detection is started.
(1) The media width is detected.
(2) The media is fed then the rear end of media
is detected.
(3) It returns to the Local when the detection is
completed.
Notes when using media press
• Set the pinch roller so that the media is held at
equally spaced intervals. If the pinch rollers
cannot be set at equally spaced intervals, start
over from Step 2.
• Ensure there is a dead space of 5 mm or above at
each end of the media. P.2-8).
• Set the media on the black part of the platen so
that it comes out approximately 40mm. If it is
shorter than that, it may not be able to perform the
media detection.
• After setting the media in place, set the pinch
roller pressure, referring to P.2-11 “Setting the
pinch roller pressure”.
• When installing the media, align the media’s right
edge with the slit line in the platen. Placing the
media rightward of the slit line will make it rise up
if it moves obliquely, and this could cause
damage to the head.
• If a media is misaligned to the right/left more than
fixed position, a error message “MEDIA SET
POSITION R” or is displayed. Set the media
again.
To Next Page
Loading...
