2-23
2
2
2
2
2
Setting the tool conditions
You can register the cutting speed and the pressure depending on the sheet or the tool type to be used. (Tool condition)
Kinds of the Tool Conditions
A tool condition consists of cutting conditions (CUT1 to CUT7), printing-with-a-pen condition (PEN).
Kinds Description
Cutting Condition
(CUT1 to 7)
This is a tool condition when a cutter is used.
About Half Cutting
You can cut on the dotted line, not to cut sheet out. (Half cut)
When you set half cut to valid (ON), you can use the half cut function.
The cutting condition changes from CUT to HLF when Half Cut is changed to “Valid (ON)”.
Plotting Condition
(PEN)
This is a tool condition when the pen is used.
OFFSET
The distance from the center of
the cutter holder to the cutter
blade. (0.01mm)
PRESS
The pressure required for cutting. (g)
SPEED
The speed of cutting.
Cutting condition No.(1 to 7)
When you press the , it
moves to the half cut condition.
CUT LENGTH
Length to be cut. (mm)
HALF LENGTH
Length to be left (not to be
cut). (mm)
HALF PRESS
Pressure of left part. (g)
HALF
Valid (ON) or invalid (OFF) of half cut.
Cutter
Set the length to be
left (not to be cut)
with HALF LENGTH.
Sheet
Set the length to
be cut with
CUT LENGTH.
Set the cutting
pressure with
HALF PRESS.
• The illustration above is the image. The shape of cut surface differs depending on the
cutting conditions.
PRESS
The pressure required for plotting. (g)
SPEED
The speed of plotting.
To Next Page
Loading...
