2-24
Select the tool condition
Before cutting (plotting), select the tool condition
depending on the sheet and the tool type to be used.
1
Press the (TOOL設定) key in LOCAL
mode.
2
Press the key to select a tool
condition to be used.
• Each time you press the [FUNC1] key, the tool
condition is switched as follows.
3
Cutting. ( P.2-22)
Set the Tool Conditions
Set the condition to cut or to plot with a pen.
Setting contents of cutting condition (CUT1 to 7):
Cut speed (SPEED)/ cut pressure (PRESS)/ OFFSET
value/ Half cut
Setting contents of plotting condition (PEN):
Plotting speed (SPEED)/ pen pressure (PRESS)
1
Press the (TOOL 設定 ) key in
LOCAL.
2
Press the key to select a tool
condition to be set.
3
Press to set the cutting speed.
• Set the moving speed of the tool for cutting or pen
plotting.
• Setting values : 1 to 10cm/s (settable by 1cm/s
step)
15 to 70cm/s(settable by 5cm/s
step)
4
Press to move the cursor to cutting
pressure (PRESS).
5
Press to set the cutting
pressure.
• Set the pressure that the tool presses the sheet
for cutting or pen plotting.
• Setting values : 10 to 20g (settable by 2g step)
25 to 100g (settable by 5g step)
110 to 500g (settable by 10g
step)
6
Press to move the cursor to OFFSET.
7
Press to set the offset value.
• When you set the cutting condition (CUT1 to 7),
set the distance between the center of the cutter
holder and the blade tip.
• Setting values : 0 to 250 (0.00 to 2.50mm)
(settable by 0.05mm step)
8
Press to move the cursor to half cut
ON/OFF.
9
Press to set ON/OFF.
• When you perform half cut, select ON and
proceed to the Step 10.
• When you do not want to set AUTO CUT, select
"OFF" and proceed to Step 16.
10
Press to move the cursor to pressure
setting of left part (not to be cut).
11
Press to set pressure.
• Set the pressure of the left part (not to be cut)
when performing half cut.
• Setting values : 0 to 300g (settable by 5g step)
12
Press to move the cursor to the
setting of length to be left.
13
Press to move the cursor to the
setting of length to be left.
• Set the length to be left not to be cut when
performing half cut.
• Setting values : 1 to 5mm (settable by 0.1mm
step)
14
Press to move the cursor to the
setting of cut length.
15
Press to set the cut length.
• Set the length to be cut when performing half cut.
• Setting values : 5 to 150 mm
(5 to 20mm: 1mm step, 20 to
150mm: 5mm step)
16
Press the key to register the
set contents.
• Return to the local.
• When the cutting (plotting) pressure setting is
completed, proceed to the setting of the
• OFFSET value. When you set the plotting
condition (PEN), you cannot set the OFFSET
value and half cut. Proceed to the Step 16.
• The maximum pressure at selecting PEN is 150g.
• Nothing is displayed on the LCD if "0" is specified.
• The set value is retained even when the power is
turned “OFF”.
To Next Page
Loading...
