2-26
Start cutting
1
After completion of setting the origin,
press the (REMOTE).
• The screen changes to REMOTE, and data can
be received from the PC.
2
Transmit data to be cuted from the PC.
• On receiving the data, the plotter performs cutting
while displaying the remaining amount of the
data.
• Upon completion of cutting, the display changes
as shown at below.
Bringing the cutting to a halt
To temporarily stop the plotter during cutting, press the
[FUNC3] (REMOTE) key once. Another press of the key
will make the plotter resume cutting.
Stopping a Cutting Operation
(Data Clear)
If you want to stop a cutting operation of the received
data, clear the data.
1
Press the key, and then press the
(DATA CLEAR)
in LOCAL.
2
Press the key.
• The reception buffer is cleared, and the present
mode returns to LOCAL..
Cutting a media
By using the keys on the operation panel, you can cut the
media at any position.
1
In Local, Press .
• It enters into the origin setting mode.
• By pressing [] , feed the media to the cutting
position.
2
Press the key.
• The media is cut.
• When the cutting has been completed, the current
mode returns to LOCAL.
• In case the media has slipped off the plotter
during cutting operation, turn off the power
immediately; otherwise, the main unit may be
damaged.
• The LCD will show the error message “ERROR
902/ DATA REMAIN” if you try to execute any
function that can initiate some action during
temporary suspension or any operation that can
affect the command coordinate system.
• If the error message appears, let the plotter
complete the cutting for the remaining portion of
the data or discontinue the cutting by executing
data clearing ( P.2-26).
When the cutter is selected
When the pen is selected
• When clearing the data, the process will not
restart even if you press the [FUNC3] (REMOTE)
key.
• After clearing the data, switching to the remote
mode and receiving another data, new data will
be cut.
• Do not perform the data clearance during the data
transmitting.
• Even after performing the data clearance, the
received data is stored in the reception buffer.
To Next Page
Loading...
