MIMAKI CJV300-130 - Feed Speed, Auto Cleaning, and Interval Wiping

3-7
Chapter 3 Setup
3
2
2
2
Setting of Feed Speed
Changes the media feeding speed in printing.
1
Press the
(MENU)
key in
LOCAL.
• SETUP MENU will be displayed.
2
Press the
(PAGE>)
, and then press
.
• “FEED SPEED” will be selected.
3
Press the key.
4
Press to select a set value, and
then press the key.
• Set value : HOST / 10 to 200%
5
Press the key several times
to end the setting.
Setting Auto Cleaning
You can set the machine so that it counts the number of
printed files or the length or time after printing has been
completed, and performs cleaning automatically if required.
You can select the auto cleaning setting from three types
below:
• PAGE : Set the cleaning intervals by the number of
printed files.
• LENGTH : Set the cleaning intervals by the printed
length.
• TIME : Set the cleaning intervals by the printed
time.
The machine can perform a stable printing operation with
its heads always kept clean.
1
Press the
(MENU)
key in
LOCAL.
• SETUP MENU will be displayed.
2
Press the
(PAGE>)
, and then press
times.
• “AUTO CLEANING” will be selected.
3
Press key, and then press
to select the type of auto cleaning.
• There are “PAGE”, “LENGTH” and “TIME” for
auto cleaning.
FILE : When the set number of prints has
been completed, the machine
performs head cleaning automatically.
LENGTH : When the set length has passed, the
machine performs head cleaning
automatically.
TIME : When the set time has passed, the
machine performs head cleaning
automatically.
• If you do not set auto cleaning, first select “OFF”
and then proceed to the Step 6.
4
Press key, and then press
to select the cleaning interval.
• Depending on the auto cleaning type selected in
the Step 3, the setting value differs.
For FILE : 1 to 1000 file
For LENGTH : 0.1 to 100.0m (in 0.1m increment)
For TIME : 10 to 120min (in 10min increment)
5
Press key, and then press
to select the cleaning type.
• Set Value : NORMAL/ SOFT/HARD
6
Press the key.
7
Press the key several times
to end the setting.
Setting Interval wiping
When the set time has passed, nozzle face of the head is
cleaned automatically to remove ink droplets on the
nozzle face.
In case that deflection, nozzle missing, or symptom which
ink droplets fall down occurred, set the interval between
each operation shorter.
1
Press the
(MENU)
key
(<<)
in LOCAL.
• SETUP MENU will be displayed.
2
Press the
(PAGE>)
, and then press
4 times.
• “INTERVAL WIPING” will be selected.
3
Press to set intervals.
• Set Value : 3 to 255 Minutes, OFF
• When [OFF] is set, periodical wiping is not
executed.
4
Press the key.
5
Press the key several times
to end the setting.
• Depending on the state of the heads, etc., the
image quality deterioration may not be improved
even with this function performed.In this case,
contact our service office or the distributor in your
region.