3-10
Chapter 3 Mchine setting
Setting a AUTO Power-off
When no operation has been performed for the set time,
the power supply is automatically turned “OFF”.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press 3 times, and then press the
key.
• “AUTO POWER OFF” will be selected.
3
Press to select a set value, and
then press the key.
• Set Value : none, 10 to 600min
4
Press the key several times
to end the setting.
Setting Take-up unit
For setting whether the take-up unit is used or not used.
Also, when the optional tension bar is installed, for setting
whether the tension bar is used or not used.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press , and then press the
key.
• “TAKE-UP UNIT” will be selected.
3
Press to select a set value, and
then press the key.
• Set Value : ON/ OFF
4
Press the key several times
to end the setting.
Setting the Display of Media Residual
Whether the screen displays the remaining amount of a
media is set.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press the
(>>)
, and then press the
key.
• “MEDIA REMAIN” will be selected.
EVENT MAIL
Server Setup
(P.3-14)
SMTP Address Set the SMTP server.
SMTP Port No. Set the SMTP port number.
SENDER ADDRESS
Set the e-mail address to be used as the sender mail
address.
Authentication
POP before
SMTP
Set the SMTP server authentication method (SMTP
authentication).
SMTP
Authentication
OFF
User Name
*2
Set the user name used for the authentication.
Pass Word *2 Set the password used for the authentication.
POP3 Address
*3
Set the POP server.
APOP *3 Set ON/ OFF of APOP.
Transmit Test
(P.3-15)
Send the test e-mail.
RESET
( P.3-16)
All setting values are returned to the status
default.
*1. Settable when both of DHCP and AutoIP are [OFF]
*2. Settable only when Auth. is not OFF
*3. Settable only when Auth. is POP before SMTP
Function name Set value Default Meaning
• If the machine received data from the PC in the
auto-power-off status, the power supply is turned
ON, however, printing operation is not started
automatically.
When the media
remaining amount
display is turned to
"ON"
the remaining amount of a media is
displayed in Remote.
(However, when a leaf media is used,
the length of the media to be printed is
displayed.)
When the media
remaining amount
display is turned to
"OFF"
the remaining amount of a media is not
displayed in the Remote.
• The amount of a media that has been fed by the
printing and jog keys is reflected in the remaining
amount of a media.
• The length of a media (initial value of the
remaining amount) is entered when a roll media is
detected.( P.2-11)
• The setting configured here does not become
effective unless media detection is performed after
the setting has been complete.
To Next Page
Loading...
