4-3
Chapter 4 Setup
4
2
2
The area where registration marks and
designs can be arranged
• The TP1 starting position must be 20 mm or more away from
the leading edge of the sheet.
• The TP2 end position must be 45 mm or more away from the
tail end of the sheet.
Mark Form : Type 1
Mark Form : Type 2
No-plotting area around the
registration marks
An area around a registration mark (from the mark origin
to the mark size area) is a non-plotting area. There must
be no data plotted or stain in this area; otherwise, a wrong
origin may be detected or a mark read error can occur.
Example of cause of wrong detection 1
There is a line outside the registration marks
Example of cause of wrong detection 2
The distance between registration marks (TP2 and TP1 or
TP4 and TP2) is smaller than the mark length (for Type 2)
Available cutting
area
Pinch roller
45 mm or
more
A : Between 50 to
3000 mm
20 mm or
more
B : 50 mm or more
The area where
cutting is permitted
The area where
cutting is permitted
Available cutting
area
Pinch roller
45mm+(
トンボ
の長さ
/2
）以上
Keep the marks
away from the
pinch rollers.
A : Between 50 to
3000 mm
B : 50 mm or more
20mm+(
トンボ
の長さ
/2
）以上
• If a wrong mark origin is detected, the cutting will
be performed in a wrong area.
Mark size
Mark Form : Type 1
No-plotting area
Mark
Mark Origin
Mark Form : Type 2
Mark size
No-plotting area
No-plotting
area
Mark Origin
Detected wrong
mark origin
Space larger
than the mark
length
Space larger
than the mark
length
To Next Page
Loading...
