4-9
4
2
2
Setting the CUT MODE
This is to set the cutting quality.
There are the following three type for cut mode.
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press twice, and then press the
key.
• “CUT MODE” will be selected.
3
Press to select the setting
value, and then press the key.
• Set value : Standard, high speed, High quality
4
Press the key several times to
end the setting.
Set the distance compen-
sation
When you cut the long data, the cut length may have
difference depending on the sheet thickness. In addition,
depending on the difference of the grid roller diameter, the
moving amount of right and left of the sheet may have
difference. Correct these differences.
You can select the distance correction from eight types
(No. 1 to No. 8).
Find compensation value
Compensation value = Measured value of the OFF line -
Input reference length
Ex.) • Actual measured value of OFF line:999.0
mm
• Entered standard length:1000 mm
• 999.0 - 1000 = -1.0 mm / (correction value)
Setting value :
• Standard value
A direction : 500, 1000, 1500, 2000, 2500
(mm)
B direction : 200, 400, 600, 800, 1000
(mm)
• Correction value
A direction : Standard length ± 5%
(0.1mm step)
B direction : Standard length ± 5%
(0.1mm step)
• Plotting offset : 0 to 300mm
Setting procedures
1
Set a media ( P.2-4)
• Set the sheet to plot the distance correction
adjusting pattern.
2
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
3
Press twice, and then press the
key.
• “ADJUST DISTANCE” will be selected.
Setting Description
Standard This is a regular cutting mode.
High speed
This is used to perform cutting in a short time (it
is not appropriate for the heavy media).
High quality
This is a cutting mode used to give priority to
cutting quality.
Select “QUALITY” in any of the following cases:
• Characters whose sizes are 10 mm or less are to
be cut
• Picture patterns or characters that have many
sharp corners are to be cut
• Minute cutting is to be performed
However, the edges of finished patterns may be
rugged if the data sent from the host computer is
too complicated. In such a case, select “HIGHspd”
for smooth finish.
• With “QUALITY”, the cutting speed is limited to 20
cm/s.
Compensated
line
Reference line
Pinch roller
To Next Page
Loading...
