MIMAKI CJV300-130 - Page 86

4-10
4
Press to select ON, and then
press the key.
• The correction value registered in AR (right side
of front-back direction), AL (left side of front-back
direction) and B (right-left direction) of No.1 are
displayed.
5
Press to select the distance
correction number to register, and then
press the key.
• The standard length (mm) that was
corrected previous time is displayed.
• If you do not perform distance correction at
all, the minimum standard length is
displayed.
• When you change the length unit (mm/
inch) from you corrected previous time, the
under screen appears.
6
Press to change the standard
length of A direction (front-back direction),
and then press the key.
• The standard length of A direction becomes
standard length of AR (right side of front-back
direction) and AL (left side of front-back direction).
• When you change the standard length, the
distance correction value (AR, AL) corrected
previous time is cleared.
• Moves to the standard length setting of B
direction.
7
Press to change the standard
length of B direction (right-left direction),
and then press the key.
• When you change the standard length, the
distance correction value (B) corrected previous
time is cleared.
8
Press to specify the plotting
position of the distance correction
adjusting pattern, and then press the
key.
• Offset all line segments (AR, AL, B) in the sheet.
• Plot the adjusting pattern.
• If a paper is not set, or, the paper size is too small
and the standard length cannot be plotted,
plotting is not performed. In such a case, when
you press the [ENTER] key, you can enter the
correction value without plotting.
9
After printing is completed, the current
correction value is displayed.
10
Actually measure OFF lines of AR, AL and B.
• Move the clamp lever to the rear side, remove the
sheet and measure.
11
Perform the operations in Steps 2 to 9.
• As the sheet is not set, the correction entry screen
is displayed without performing printing.
12
If the measured value is different from the
standard value, change the correction
value with .
13
Press the key to register the
correction value of AR direction.
• You can register it by [>} key.
• Moves to the standard length setting of AL
direction.
14
In the same way as the Step 10, enter the
correction value of AL with .
15
Press the key to register the
correction value of AL direction.
• You can register it by [>} key.
• Moves to the standard length setting of B
direction.
16
Change the correction value of B direction
with , and the press the
key.
• Register the correction value of B direction.