4-15
4
2
2
Check the sensor for the registration mark
detection
Prepare the media on which the registration mark is
printed.
1
Press in Local.
• Enter the jog mode
2
Press to move the tip
of the pen to the registration mark
detection position
• Perform registration mark detection at a position
1mm or more away from the registration mark.
3
Press the key to terminate the
jog mode.
• The plotter returns to the Local.
4
Press the
(MENU)
(>>)
key.
• Cuttibg MENU will be displayed.
5
Press
(>>)
key.
• “MAINTENANCE” will be selected.
6
Press the key.
• “MARK SENSOR” will be selected.
7
Press the key.
• “SENSOR CHECK” will be selected.
8
Select the length of the registration mark
and shape of the registration mark
detection.
• For details on setting the [SIZE] and [FORM],
refer to the ”Setting of Detecting the Registration
Marks”. ( P.4-5)
9
Press the to perform registration
mark detection. ( “Detect operation”)
Detect operation
1
Scan in the B direction (plus direction) to
detect the line.
• The buzzer sounds when the line is detected. If
the line is not detected, the buzzer does not
sound.
2
Scan in the B direction (minus direction) to
detect the line.
3
Scan in the A direction (plus direction) to
detect the line.
4
Scan in the A direction (minus direction) to
detect the line.
• If you move the head and sheet manually, you
cannot perform the right response check. Be sure
to perform it via the following operations.
• For conditions of already printed registration mark,
refer to “Precautions in inputting data with
registration marks” ( P.4-2).
• The setting values are kept in memory even when
the power is turned off.
• The settings performed here for shape of the
registration mark and length of the registration
mark are reflected in the settings of “MARK
DETECT”.( P.4-5)
• The detection speed selected here will be used in
the registration mark detection operations that are
executed from here on.
• The pointer offset value selected by this operation
is not initialized by SETUP RESET operation.
1 mm or
more away
Mark detection
position
Mark :
Type 1
Mark :
Type 2
Minus
direction
Plus
direction
Mark length
Scan in the A direction
Minus
direction
Plus
direction
Scan in the B direction
To Next Page
Loading...
