MIMAKI CJV300-130 - Page 92

4-16
5
Follow the Steps 1 to 4, and confirm if the
buzzer sounds 4 times.
• When the detection behavior completes
successfully, the buzzer sounds 4 times.
• If the buzzer does not sound, contact our sales
office after checking the registration mark
condition.
Alignment of MARK SENSOR
The offset value of the cutter and the mark sensor can be
adjusted.
Set the sheet on which the register mark is printed.
1
Install a cutter in the tool holder.
2
Press the
(MENU) (>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
3
Press
(>>)
key.
• “MAINTENANCE” will be selected.
4
Press the key.
• “MARK SENSOR” will be selected.
5
Press .
• “SENSOR OFS” will be selected.
6
Press the key.
• After detecting registration mark (1pt), cut the
center line of the register mark and both sides of
five auxiliary lines every 0.2 mm.
7
Enter the corrected value (mm) by
pressing the for the A direction,
or the for the B direction.
• If misaligned by +0.2 mm, enter [-0.2].
8
Press the key.
• The plotter will return to the local after registering
the compensation value.
Correct the light pointer position
If the plotter fails to recognize any registration mark
properly, the possible cause is an error in the positional
relationship between the MARK sensor and the light
pointer.
In this case, adjust the position of the light pointer.
1
Install a cutter in the tool holder.
2
Load the copy paper.
3
Press the
(MENU) (>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
4
Press
(>>)
key.
• “MAINTENANCE” will be selected.
5
Press the key.
• “MARK SENSOR” will be selected.
6
Press twice.
• “POINTER OFS” will be selected.
7
Press the key.
• A 10 mm by 10 mm cross pattern will be cutted.
• The light pointer turns on and moves to the center
of the cross pattern.
8
Press to adjust the
light pointer position so that the center of
the light pointer is in alignment with the
center of the cross pattern.
9
Press the key.
• The plotter will return to the local after registering
the compensation value.
A direction
Misaligned by +0.2 mm from the center line of
the register mark ( ) in the A and the B
direction.
B direction
• The setting values are kept in memory even when
the power is turned off.
• The sensor offset value selected by this operation
is not initialized by SETUP RESET operation.
• The value registered in the [POINTER OFS] is not
initialized even by executing the “SETUP RESET”.
(P.4-14)