4-18
Cutting out Data without Register
Marks (ORIGIN OFFSET)
To print & cut the data without register marks, adjust the
misalignment between a printed image and the cutting
line (Origin Offset).
Adjust the misalignment between the print origin and the
cutting origin.
According to the scanning speed in the Y direction, 540dpi
and 720dpi has the different ink drop positions while
printing. Adjust with the resolution you want to print.
1
Set a PVC medium ( P.2-4), and attach
the eccentric cutter for cutting ( P.2-20).
2
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
3
Press
(>>)
and then press the
key.
• “SETUP SUB MENU” will be selected.
4
Press
(>>)
key.
• “MAINTENANCE” will be selected.
5
Press 3 times, and then press the
key.
• ORIGIN OFFSET” will be selected.
6
Press to select 540dpi or 720dpi,
and press the key.
• Select one depending on the resolution you want
to print with after adjustment.
•Press [][][] to change the print start position
(print origin).
•Press [] to go to Step 8.
7
Press the key to print & cut the
adjustment pattern.
• The adjustment pattern shown on the below is
printed & cut.
8
Remove the cut pattern, and adjust the
misalignment.
• The pink portion that remains after the pattern is
peeled off is the misalignment amount.
• You can read off the misalignment amount from
the scales on the adjustment pattern.
• If the portion remaining after cutting is in the
upper part in the X direction (positive portion of
the scale) and in the right part in the Y direction
(negative portion of the scale), enter “+” for the X
offset and “-” for the Y offset.
•Press [][][][] to enter an offset value of the
cutting line.
• Select X/Y direction :Press [][].
• Enter an offset value :Press [][].
9
Press the key.
• The adjustment pattern will be printed once more.
Carry out the procedure from step 8 onward, and
repeat this until the misalignment disappears.
• Press the [END/POWER] key several times to
return to LOCAL.
• This machine stores an adjustment value of either
540dpi or 720dpi. Select the resolution of the
printing to be performed after adjustment.
• Before adjusting, set a PVC medium and attach
the provided eccentric cutter for cutting.
• Before setting in this section, perform “Setting
Media Correction” ( P.2-16).
• Even if adjusting in this section, some data may be
slightly misaligned depending on the print mode,
medium features, the pinch roller setting or the
other causes. If so, adjust again.
To Next Page
Loading...
