MIMAKI CJV330-160 - Reading Range of Register Marks

Chapter 4 Cutting Data with Register Marks
110
Mark shape
Type 1 Type 2
Register mark length (B) × 2 + α, up to 1,000 mm
(C)
(B)
(B)
(C)
Register mark length (B) + α, up to 1,000 mm
(C)(B)
(B)(C)
l
Mark Origin Mis-detection Example
• If the spacing between register marks (C) is narrow, as shown in the figure below, the machine may fail
to detect them.
(B)(C)
(B) (C)
Reading Range of Register Marks
This machine can detect register marks in the range shown below. If the margin is small, the edge of the
media may be incorrectly identified as a register mark.
When copying data with MIMAKI RIP software (RasterLink), leave a space of at least 210 mm from the rear
edge of the media.