MIMAKI CJV330-160 - Chapter 5 Using the XY Slitter; Slitting Process; Slitting Simultaneously with Printing

Chapter 5 Using the XY Slitter
118
5.1 Slitting Process
Slitting Simultaneously With Printing
1.
Enable the XY slitter.
On the LOCAL mode screen, select [MENU] > [Function Setting] > [Finisher] > [XY Slitter].
2.
Loading the Media
Put the media through the XY slitter. "Loading the Media"(P. 122)
3.
Printing Guide (Slit) Line
Select "Slit at the same time as printing" in RasterLink. "Printing Guide (Slit) Line"(P. 127)
4.
Mounting the X Cutter
Cut the frame for positioning the media guides. Align the X cutter with the printed guide (slit) line.
"Mounting the X Cutter"(P. 130)
5.
Placing the Media Chute
"Placing the Media Chute"(P. 134)
6.
Printing RIP Data
RIP data is slit at the point it is printed. "Printing RIP Data"(P. 135)