Chapter 5 Using the XY Slitter
124
11
Lower the clamp lever of the XY slitter.
• The XY carriage can be moved by hand when the XY slitter clamp lever is lowered.
12
Move the clamps of the XY slitter.
• Position the clamps on both edges and the center of the media.
• Align the clamps with the mark (square hole) positions.
• Position the clamps so that the clamp centerlines align with the marks (square holes). The
media cannot be transported correctly if the clamp centerlines are not aligned with the
marks (square holes).
Good example Bad example
Mark (square hole)
Mark (square hole)
13
Engage the media on to the tension bar and pull it out from the bottom.
14
Press to feed the media by about 240 mm.
To Next Page
Loading...
