MIMAKI CJV330-160 - Registering Nozzle Recovery

Chapter 6 Settings
144
Item
Setting
*1
Details
Cleaning Check ON/OFF Sets whether nozzle checking is performed after head cleaning is
completed.
Interval Wiping OFF / 3 to
255 min
Wiping starts when the set print time is exceeded.
Refresh Weak/
Standard/
Strong
Select the refresh (flushing) time during printing.
Waste Ink Tank - Resets or corrects the waste ink tank usage count. "Waste Ink
Tank Replacement"(P. 192)
Reset Waste Ink
Volume
- Resets the waste ink tank usage count. "Replacing the Waste
Ink Tank"(P. 193)
Adjust Waste Ink
Volume
- Corrects the waste ink tank usage count. "When "Check Waste
Ink tank" message appears"(P. 192)
Tank Capacity - Displays the waste ink tank capacity.
Air PG - Expels any air in the ink paths.
• Use this if Ink End is still displayed after ink replacement.
*1. The default settings are shown underlined.
Registering nozzle recovery
Allows other nozzles to be used for printing if maintenance actions like nozzle washing fail to resolve print
defects (e.g., nozzle clogging, deflection).
• Nozzle recovery can be specified for up to ten nozzles per row. The time taken for printing
remains unchanged even when nozzle recovery is set.
• Load media at least 500 mm wide. You cannot print the entire pattern if media less than 500
mm wide is used.
1
Position the media.
2
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
3
Select [Nozzle Recovery] > [Print], then press the [ENTER] key.
• Print a nozzle recovery pattern.
• The Select Entry Nozzle screen appears once printing is complete.
100 0102030405060708090
H1-D K
H1-C Y
H1-B C
H1-A M
1
101
201
301
401
510 0
No.203
H1-A M
Ink Color
Nozzle row number
Head number
Approx. 300 mm
Approx. 180 mm