Chapter 6 Settings
145
4
Select the "head number and nozzle row" for nozzle recovery, then press the [ENTER] key.
SELECT ENTRY NOZZLE
Head1-A
>
>
Head1-B
>
Head1-C
>
Head1-D
>><<
>
Head1-E
Head number
Nozzle row number
5
Enter the "nozzle number" for nozzle recovery, then press the [ENTER] key.
• Select the entry number before entering the nozzle number.
• Nozzle recovery is set.
Head2-D
No.1
No.2
16
128
No.3
184
No.4
OFF
No.5
OFF
>><<
Entry number 1 to 10
Nozzle number
6
Press the [ENTER] key once entry is complete.
• Select [Maintenance] > [Nozzle Recovery] > [Test Print], then select "ON" to perform
nozzle recovery and test printing. "Test Printing"(P. 76)
Nozzle check
This is used to check if the nozzles are clogged before printing starts. Sets whether to perform maintenance
functions automatically if nozzle clogging is detected.
If ≥ the set value
[Printing Check]
ON
The nozzles are not checked.
OFF
Performs nozzle recovery automatically.
Nozzle check (nozzle clogging detection)
Continue Printing
If less than the set value
[Judgment Condition] setting for nozzle clogging
detection
[Nozzle Recovery] (cleaning followed by nozzle
checking)
* Repeated by [Retry Count] cycles.
[Judgment Condition] setting for nozzle clogging
detection
Stop Printing
If ≥ the set value
[Auto Nozzle Recovery]
ON
OFF
If less than the set value
6
To Next Page
Loading...
