Chapter 6 Settings
147
Item
Setting
*1
Details
• The Mimaki RIP software (RasterLink) does not allow the
user to specify Print End. If the machine is set to "Host", the
time will be "0 min".
Power Setting - Sets the times to turn the power on and off automatically.
Auto Power-off 5 to 15 to 60
min
Sets the time until the power is automatically turned off.
Auto Power-on - Sets the time to automatically turn on the power.
Setup ON/OFF Sets whether to turn on or off the power.
Time 0:00 to 23:59 Sets the time to turn on the power.
Day Monday to
Sunday
Sets whether to turn on or off the power on each day of the
week.
Nozzle Check ON/OFF Automatically executes the nozzle check function when the
machine is started with auto power-on. Performs nozzle
recovery (cleaning followed by nozzle checking) if "nozzle
clogging" is detected.
Cleaning Soft/Normal/
Hard
Sets the cleaning type.
Retry Count 0 to 3 times Performs nozzle recovery (cleaning followed by nozzle
checking) for the specified number of times.
Top Blower ON/OFF Sets the blowing fan operation during printing.
Strength AUTO/Low/
High
Sets the blowing fan wind strength.
Drying/Exhaust Fan - Set when the optional drying/exhaust fan is used. For more
information, refer to the operation manual for the drying fan unit.
Stop Time OFF/10 to 120
min
Sets the time during which the drying/exhaust fan operates after
printing. After the set time passes, the fan stops.
ON/OFF ON/OFF Set to "ON" to operate the drying/exhaust fan when printing is
not performed.
Use PR Number Query
*CJV only
ON/OFF Sets whether to display the screen for entering the number of
pinch rollers to be used after media width detection.
• ON: Displays the input screen.
• OFF: The "host" takes priority. Set this to "OFF" when
configuring pinch roller pressure settings on this machine.
"Setting the Pressure and Number of Pinch Rollers to Use
(CJV)"(P. 74)
WhiteSpace Setting - Sets the offset value from the media left and right standard
margins (15 mm).
• The left and right margins should be set to at least -5 mm
when using the media holder. This eliminates the risk of
printing on top of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the
user to specify margins. If the machine is set to "Host", the
offset value will be "0 mm" for the left and right margins.
Margin -
Margin/Left Host/-10 to 85
mm
Margin/Right
Space Btwn PP. None/10 to
500 mm
Setting the distance of the reverse feed (spaces between prints)
during continuous printing can eliminate spaces between prints.
• The reverse feed may cause sagging media, resulting in
discrepancies in the distance the media is fed. If this occurs,
rewind the media by hand to eliminate sagging before
printing.
6
To Next Page
Loading...
