Chapter 6 Settings
148
Item
Setting
*1
Details
Space Feed Mode Intermittent/
Continuous
Alters the feed method for blank space included in the image
data.
• Intermittent: Uses intermittent feeding based on the timing of
a fraction of the pass.
• Continuous: Feeds forward by skipping blank parts.
View Feed ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
Feeding Before Cut ON/OFF Sets whether to feed media before cutting the media.
Illumination - Turns the light inside the printer on and off.
LightingUp Type Auto/Manual Sets whether to turn the light on or off during printing and when
the cover is opened.
LightingUp
Extention
None/1 to 5 to
10 min
Displayed when LightingUp Type is set to Auto. Sets the time
during which the light is turned on after printing.
Start Up Lighting ON/OFF Sets whether to turn the light on or off when the power supply
switch is turned on.
Auto Remote ON/OFF Sets whether to automatically switch to REMOTE mode and
start printing if data is received locally.
Finisher
*JV/CJV only
Nothing/XY
Slitter
Selects the unit connected. The settings are displayed for the
selected unit.
XY slitter - Sets the XY slitter adjustments and functions.
Slit Position
Adjustment
- Adjusts the Y slit position.
X position -5.0 to 5.0 Adjusts the X position of the Y slit.
Y position -5.0 to 5.0 Adjusts the Y position of the Y slit.
Slit Position
Detection
- Detects [Afterwards slitting mark].
Slitting Feed - Displays the procedures from X cutter setting to slitting when
slitting afterwards.
*1. The default settings are shown underlined.
To Next Page
Loading...
