Chapter 6 Settings
151
6.6 Cutting Menu
You can set various settings related to cutting functions.
l
Menu List
Item
Setting
*1
Details
Mark Detect - Enter the conditions of the printed register marks.
Detect ON/OFF Set this to ON to cut cutting data with register marks.
Form Type 1/Type
2/Zero Margin
TP
Select three types of register mark shapes.
"Register Marks"(P. 108)
Size 5 to 40 mm Set the register mark length (B).
Line width
Register mark length (B)
"Standards for Register Mark Length and Line Width"(P. 109)
Offset X -5.00 to 5.00
mm
Change the position of the register mark origin. If the cut position
shifts in the same direction, change the position of the origin.
Mark: Type 1 Mark: Type 2
Plus X direction Plus X direction
Plus Y direction
Plus Y direction
Origin
Origin
• If "ERROR C37 Mark Org" is displayed, change the layout by
referring to the following.
"Reading Range of Register Marks"(P. 110)
Offset Y -5.00 to 5.00
mm
Detect End Key
Start
ON/OFF If you press the [END] key on the LOCAL mode screen, the cutter
unit moves over the platen so that register marks can be detected.
Sensor Level 1 to 7 Check the sensitivity of the register mark sensor. Normally, set this
to "4".
• If it cannot detect the register marks: Increase sensitivity.
• If it mis-detects the register marks: Decrease sensitivity.
Mark FillUp ON/OFF When the "Fill around the registration marks" function of the RIP
software is enabled, set this to "ON".
Detect Area - Sets the automatic register mark detection area.
6
To Next Page
Loading...
