Chapter 6 Settings
153
Item
Setting
*1
Details
Mark Cut OFF/ON Sets whether or not to add marks for use as guides when pasting
together division-cut media.
Up Speed - Set the movement speed of the media and carriage while the tool is
up.
Up Speed X AUTO/5 to 30
cm/s
Sets the media feed speed.
Setting a slower speed can reduce media offsets.
Up Speed Y AUTO/5 to 30 Sets the carriage scan speed.
Dummy Cut ON/OFF Cuts the media to make the cutting blade face a certain direction
after media detection or tool changes. (Performs a dummy cut in
front of the pinch rollers which are closest to both ends of the cutter
unit.)
If you wish to avoid damage to the media or cut cut-out characters,
set this to OFF. Perform test cutting to adjust the direction of the
cutting blade. "Test Cutting"(P. 101)
If the tool condition is set to "PEN", dummy cutting is disabled.
Sheet Type Standard/
Heavy
Set the weight of the set media.
Adj-prs Offset -9 to 0 to 9 When cutting the corners, the pressure is automatically decreased
(by about 5 g) to prevent the media from lifting up. As a result, the
cutting blade might not rotate smoothly and may leave uncut parts.
Adjust the pressure for cutting the corners if they are left uncut.
Vacuum Fan Weak/
Standard/
Strong/OFF
Sets the force with which the medium is held down during cutting.
Ordinarily, use "Weak".
Over Cut OFF/0.1 to
1.0 mm
Overlaps the start and end points so that no part of the media is left
uncut.
"Preventing uncut media"(P. 154)
Corner Cut ON/OFF Performs over cutting at corners other than the start and end point.
"Preventing uncut media"(P. 154)
Curve Mode Fast/Slow If the cut line becomes twisted, set this to "Slow". This can prevent
twisting but decreases cutting speed.
Setup Reset - Initializes the details set.
Maintenance -
Marks Sensor -
Sensor Check - Check the responsiveness of the register mark sensor.
"Adjusting the Position of the Register Mark Sensor"(P. 201)
Pointer Offset - Adjust the position of the light pointer when the positions of the
register mark sensor and light pointer do not match.
"Correcting the LED Pointer Position"(P. 202)
Sample Cut - The machine cuts a sample stored in the unit to troubleshoot
problems when data cannot be cut properly.
6
To Next Page
Loading...
