Chapter 7 Maintenance
166
Media Sensor Cleaning
Media sensors are located on the rear cover and carriage underside. The media cannot be detected
correctly if dust or debris accumulates on the sensors. Remove any debris using cotton swabs or a soft cloth.
Rear of product
Carriage underside
l
Cleaning the carriage underside sensor
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Carriage Out] > [Move To Maint. Space], then press the [ENTER] key.
• The carriage moves to the maintenance space.
3
Open the maintenance cover on the left side.
4
Clean the media sensor.
5
Once cleaning is complete, close the cover, then press the [ENTER] key.
Media Cutter Cleaning
Continuing to use a dirty media cutter may cause dust to collect on the head nozzle surface or the cutter
blade to grow dull.
• Avoid touching the cutter blade. Failure to do so may result in injury.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
To Next Page
Loading...
