Chapter 7 Maintenance
171
2
Remove the filter.
3
Wash the filter.
• Dry the filter after washing.
4
Attach the dry filter together with the fan filter cover.
• Push in the fan filter cover until the tab clicks.
When this printer is left unused for a long time
Clean as follows if the product is not used for one week or longer:
Check beforehand
Is [Ink Near End] or [Ink End] displayed?
• Maintenance liquid and ink is aspirated during the washing operation. Washing is not possible if an
error occurs during this process. Replace with new ink.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Custody Wash], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the maintenance cover on the right side.
4
Clean the cap rubber.
• "Cap Rubber Cleaning"(P. 160)
7
To Next Page
Loading...
