Chapter 7 Maintenance
172
5
Once cleaning is complete, close the cover, then press the [ENTER] key.
• The cap is filled with maintenance liquid.
• Close the cover. The cap cannot be filled with maintenance liquid while the cover is open.
This is also true if the maintenance liquid cartridge is empty.
6
Open the maintenance cover on the right side.
• Check to confirm that the cap is filled with maintenance liquid.
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
7
Close the maintenance covers.
• Close the cover. The cap cannot be filled with maintenance liquid while the cover is open.
This is also true if the maintenance liquid cartridge is empty.
8
Set the exposure time, then press the [ENTER] key.
• Print nozzle washing starts. The elapsed time is displayed on the display.
• Cleaning is performed automatically once print nozzle washing has ended.
• The cap is filled with maintenance liquid.
9
Open the maintenance cover on the right side.
• Check to confirm that the cap is filled with maintenance liquid.
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
10
Close the maintenance cover, then press the [ENTER] key.
• Pump tube (ink discharge channel below the cap) washing starts.
To Next Page
Loading...
