MIMAKI CJV330-160 - The Heater Temperature Does Not Rise to the Specified Value

Chapter 8 Troubleshooting
200
2
Select [Station Maint.] > [Nozzle Wash], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the maintenance cover on the right side.
4
Clean the wiper and bracket.
• Wiper Cleaning
5
Press the [ENTER] key once cleaning is complete.
• "Cap Cleaning Completed (Next) [ENT]" appears on the display.
6
Clean the cap rubber.
• "Cap Rubber Cleaning"(P. 160)
7
Once cleaning is complete, close the cover, then press the [ENTER] key.
• The cap is filled with maintenance liquid.
• Close the cover. The cap cannot be filled with maintenance liquid while the cover is open.
This is also true if the maintenance liquid cartridge is empty.
8
Open the maintenance cover on the right side.
• Check to confirm that the cap is filled with maintenance liquid.
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
9
Close the maintenance covers.
10
Set the exposure time, then press the [ENTER] key.
• Print nozzle washing starts. The elapsed time is displayed on the display.
• Cleaning is performed automatically once print nozzle washing has ended.
• If print defects (e.g., nozzle clogging, deflection) remain unresolved even after washing
the nozzles several times, contact your local dealer or our service office.
The heater temperature does not rise to the specified value.
This may indicate a problem with the setting.