Chapter 8 Troubleshooting
203
3
On the LOCAL mode screen, select [MENU] > [Cutting], then press the [ENTER] key.
• The Cutting menu is displayed.
4
Select [Maintenance] > [Marks Sensor] > [Pointer Offset], then press the [ENTER] key.
• A 10 mm cross pattern is drawn.
• The LED pointer turns on and moves to the center of the cross pattern.
5
Press to move the LED pointer to the center of the cross pattern.
6
Press the [ENTER] key to complete the settings.
• The settings are retained even if [Setup Reset] is selected.
7
Check the following again.
• "Adjusting the Position of the Register Mark Sensor"(P. 201)
• If the buzzer does not sound four times, check the printed register mark conditions and contact
your local distributor, our sales office, or service center.
Investigating the Cause of Cutting Failures
1
On the LOCAL mode screen, select [MENU] > [Cutting], then press the [ENTER] key.
• The Cutting menu is displayed.
2
Select [Maintenance] > [Sample Cut], then press the [ENTER] key.
3
Select the sample data, then press the [ENTER] key.
• There are two sample types: "Cut" and "Logo".
Sample
Cut Logo
• If you select "Cut", press the [ENTER] key to start cutting.
• If you select "Logo", refer to the following:
(1) Press to specify the scaling factor (1 to 999 %).
(2) Press the [ENTER] key to start cutting
• The settings are retained even if [Setup Reset] is selected.
l
Sample Cut Results
• Sample data can be cut properly, but not other data.
– There is a problem with the host PC.
• Sample data as well as other data cannot be cut properly.
– There is a problem with the printer. Increase the pressure in the Adj-prs Offset menu. "Cutting
Menu"(P. 151)
8
To Next Page
Loading...
