Chapter 2 Printing
64
4
Insert the core of the roll media on to the rear left roll holder.
• Push in until the core moves no farther.
5
Insert the rear right roll holder into the core.
• Unscrew the roll holder retaining screw before moving.
6
Tighten the retaining screw on the rear right roll holder.
7
Insert the media.
• Insert into the gap between the pinch rollers and the grid rollers.
• Inserting the media at an angle allows smooth insertion without catching or sticking.
8
Lower the clamp lever.
• Hold the media with the pinch roller and grit roller.
9
Move to the front of the machine and open the front cover.
10
Raise the clamp lever and pull out the media.
• Make sure the media does not fall to the rear.
To Next Page
Loading...
