Chapter 2 Printing
65
• Adjust the rear roll holder position so that the media does not cover the right-hand slit line
on the platen. Movement at an angle may result in damage to the print head.
Slit line
Media
Media holder
• The areas extending 5 mm from both sides of the media are margins.
11
(CJV only) Lower the clamp lever to confirm that the spacing from the pinch roller is uniform.
• "Adjusting the Pinch Roller Positions (CJV)"(P. 54)
• If the spacing is not uniform, repeat all steps from the start.
12
(CJV only) Raise the clamp lever.
13
Gently pull out the media and stop at the position where it is gently locked in place.
14
Check how far the media was pulled out.
• Pull the front edge of the media gently at several points to confirm that the media was pulled out
by the same amount.
2
To Next Page
Loading...
