Chapter 2 Printing
66
15
Lower the clamp lever.
16
Select the media to be used.
Media selection
● PVC
○ Tarpaulin
○ Unregistered
○ Unregistered
1/2
1300 mm
1600 mm
○ Unregistered
• To use unregistered media, select [Unregistered] to register the media. "Registering
the Media"(P. 72)
17
Detect the media width.
• No change: Only the right side of the media is detected.
• Media width re-detection: The media width is detected.
PVC
Media Width 1300 mm
No change
Media width
re-detection
• When slitting afterwards (Slitting the Print Media Afterwards), check to confirm that there
are no print data or marks at the media width detection sensor position. Any print data or
marks present could cause false detection, disrupting media width detection.
• If the setting for [Media Setting] > [Media Information] > [Media Width] is "MANUAL", set
the media width manually.
• If the setting for [Media Setting] > [Media Information] > [Media Remain Manage] is "ON",
the Input Media Length screen will be displayed.
• A notification reading "Media Set Position R" will appear after media width detection if the
media is too far to the right of the specified position. Reload media in the specified
position.
18
(CJV only) Enter the number of pinch rollers being used.
• If the setting for [Function Setting] > [Use PR Number Query] is "OFF", the screen for entering the
number of pinch rollers will not be displayed.
To Next Page
Loading...
