Chapter 2 Printing
67
19
Load an empty core on the take-up unit.
20
Press to feed the media until it reaches the core on the take-up unit.
• Do not put media through the XY slitter.
21
Secure the middle of the media to the core with adhesive tape.
• Only if the media edge is straight
Secure the left and right sides of the media. Pull the lower edge of the media evenly on
both the left and right sides, check to confirm that it is free of sagging and creasing, then
affix the tape.
22
Press and wrap the media about one and a half around the core.
2
To Next Page
Loading...
