MIMAKI CJV330-160 - Loading the Leaf Media (CJV)

Chapter 2 Printing
69
Loading the Leaf Media (CJV)
• The roll holder is not used with leaf media.
• Leaf media cannot be used on JV/ TS.
1
On the LOCAL mode screen, select [MENU] > [Media Setting], then press the [ENTER] key.
• The Media Setting menu is displayed.
2
Select [Media Information] > [Media Operation Form] > [Leaf], then press the [ENTER] key.
• The media bottom end will not be detected if Leaf is not selected.
3
On the LOCAL mode screen, select [MENU] > [Media Setting], then press the [ENTER] key.
4
Raise the clamp lever.
5
Open the front cover.
6
Insert the media.
• Insert into the gap between the pinch rollers and the grid rollers.
• Inserting the media at an angle allows smooth insertion without catching or sticking.
7
Adjust the position of the right media edge.
• Set the media straight so that the media does not lie beyond the slit line on the platen.
First three grit rollers from the right end on the front of the machine
• The areas extending 5 mm from both sides of the media are margins.
2