Chapter 2 Printing
71
12
Detect the media width.
• No change: Only the right side of the media is detected.
• Media width re-detection: The media width is detected.
PVC
Media Width 1300 mm
No change
Media width
re-detection
• If the setting for [Media Setting] > [Media Information] > [Media Width] is "MANUAL", set
the media width manually.
13
Detect the media bottom.
• Select [Execute].
Media detect
Start detecting the media trailing edge.
Execute
Not execute
• A notification reading "Media Set Position R" will appear after media width detection if the
media is too far to the right of the specified position. Reload media in the specified
position.
14
(CJV only) Enter the number of pinch rollers being used.
• If the setting for [Function Setting] > [Use PR Number Query] is "OFF", the screen for entering the
number of pinch rollers will not be displayed.
2
To Next Page
Loading...
