MIMAKI fine Cut 3 - Page 20

18
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
(2)Set the head withdrawal position for the length direction.
Reference position from either [Current Origin] or [Max Plot Length].
For example, the head is withdrawn to the position at +100 mm from the Max Plot
Length for the length direction in the figure.
(3)Set the head withdrawal position as the origin.
(This function is effective only for the MGL-IIc commands on Mimaki CG series.)
Check this option, for the useful operations like continuous output.
When checking “Sheet Feed Origin Renewal”, [No. Copies] or [Division Cut]
function on Mimaki plotter will not perform correctly. Uncheck “Sheet Feed
Origin Renewal” before using [No. Copies] or [Division Cut] function.