27
○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
3 Set the registration mark to recognize continuously.
4 Check [Auto Cut] to enable sheet cut automatically after
completing each cutting operation.
Click Set to set the Auto Cut Setup information.
Click Set .
5 Click Plot button in the Plot dialog.
Set the maximum length from the last line to the
cutting point. (See the figure A below.)
Check [Detail Cutting] to cut a data at every line.
Select “Roll sheet” (left) icon.
Set the continuous numbers to each
direction, vertical and horizontal.
In case the continuous number
is indeterminacy, input the maxi-
mum numbers, “9999”.
Select the first detect points
of the register mark.
Select the second and the
subsequent detect points of
the register mark.
• When detecting a larger data, set
more detect points for the second
and the subsequent detect points
to cut more precisely.
• When detecting a smaller data,
set less detect points on the
second and the subsequent
detect points to reduce the
detecting time.
A
< Cut
< Cut
< Cut
< Cut
To Next Page
Loading...
