MIMAKI fine Cut 3 - Page 30

28
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
• In case the printed data by a take-up functioned plotter (Mimaki JV series etc.) rolled as
a paper tube
Rotate the data to 180-degree in the FineCut, and set the paper tube on the CG-FX directly:
Enables to cut the data continuously. (No need for rewinding the roll)
Output to the printer
Mimaki CG-FX series
Rotate the data to 180-degree before recognizing a register mark in the FineCut.
Output Direction
Prot Direction
Confirm the margins on the sheet.
(see page 25)