30
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
< Cut a Leaf sheet continuously >
• Only one set of the registration marked data (4 marks) is available to cut
continuously. In case two or more sets of the register marked data exists in
a sheet, cannot cut continuously.
• Set the same size and position between the output leaf sheet size and the
print position.
1 Set a output result on a plotter to detect registration mark.
(Refer to page 25)
For the procedure of registration mark detection, refer to the Mimaki CG-FX series
operation manual.
2 Click Detect Mark button in the Plot dialog.
Recognize the registration marks.
STEP3
Set the register mark
to recognize continu-
ously.
To Next Page
Loading...
