MIMAKI fine Cut 3 - Page 42

40
○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
< Buttons >
End Button
Closes the Plot dialog.
Plot Button
Starts cutting. When the mark is displayed to the left of Plot button, the object
overflows from the cutting area. Move the object to fit it into the cutting area.
Load Sheet Size Button
Loads the sheet size set to the plotter.
When the mark is displayed to the left of Load Sheet Size button, the sheet size
of the plotter cannot be loaded.
Set the plotter to the REMOTE mode before clicking Load Sheet Size button to load
the sheet size.
Initialize Button
Initialize the condition.
Detect Mark Button
By performing registration mark detection using Mimaki CG-EX series and Mimaki
CG-FX series cutting plotter with mark sensor, automatic size correction is performed
for the read registration mark.