Mimaki Europe B.V.
Industrial Products
Print on the thick and heavy media
17
• Printing on the substrate of up to 2 inches (50mm) thick
• The maximum loadable weight of substrate is up to 110lb (50kg/m²)
• About the head gap
• The gap between the head and the substrate should be less than 2mm
• If the gap is set wider than 2mm, the ink drop tends to become mist before it reaches onto the substrate
• Furthermore, if the gap is to wide, the reflected light from the UV curing lamp increases. This leads to a cause of an
error of the ink droplet onto the substrate or the nozzle clogging, because the reflected light may increase the
viscosity of the ink mist
Media
Scan Direction
Less than 2mm of head gap
is recommended
The thickness of media
should be less than 50mm
To Next Page
Loading...
