Chapter 3 Convenient Usage
3-33
Nozzle Check Menu
This configures the operations related to Nozzle Missing check function.
Nozzle Check Menu List
Item Set value Details
Printing Check
"Printing Nozzle Check Settings" (P. 3-34)
ON/OFF Set this to on if you want to perform
nozzle check when starting online
printing.
(ON) CHECK INTERVAL FILE 1 to 30 to 100 files Checks the nozzle periodically after a
set length.
LENGTH 0.1 to 30 to 50.0 m Checks the nozzle periodically after a
set number of files.
*1
CONTINUATION PRINT ON/OFF
ACTION CLEANING NORMAL/HARD/
SOFT
Set the type of cleaning to perform
during the recovery operation.
RETRY COUNT 0 to 3 times Retries the operation a set number of
times.
AUTO NOZZLE RECOVERY
"Auto Nozzle Recovery Settings" (P. 3-36)
ON/OFF Set this to automatically perform
nozzle recovery.
Judgment Condition
"Judgment Condition
Settings" (P. 3-36)
C, M, Y, K, Lc, Lm, W,
Cl, Pr
1 to 64 Sets how many nozzles for each color
must be detected as missing to judge
"Nozzle Missing". (16 nozzles in each
nozzle line)*
2
*1. If in the middle of the printing process, the machine reaches the set length, the nozzle is checked at the beginning of the next print.
*2. Nozzle recovery may not be applicable depending on the print conditions.
Printing Nozzle Check Flow
Nozzle check is performed at the start of the printing process according to the following flow.
• This is enabled when "Printing Nozzle Check" is set to "ON".
• RETRY and AUTO NOZZLE RECOVERY are set only when this setting is enabled.
1.
Nozzle check → judgment
Detects missing nozzles.
2.
Action → nozzle check → judgment
If more missing nozzles than the "Judgment Condition" are detected after the nozzle check, perform cleaning
and run the nozzle check again.
3.
Retry → judgment
If more missing nozzles than the "Judgment Condition" are detected after the recovery operation, the
recovery operation is re-run.
– This applies if the "RETRY COUNT" is set to 1 or more.
3
To Next Page
Loading...
