Chapter 4 Maintenance
4-17
6
Wipe any ink on the sides of the head and carriage using a clean stick.
• Never rub the nozzle part.
Nozzle part (Never touch)
Clean the side of the
head (dark gray part)
with a clean stick.
Clean using a clean stick.
• Clean the wiper and the bracket until they look like the picture.
• Clean the nozzle surface if the shape of the cap rubber is visible on it.
• If you need to leave your seat during maintenance, press the [ENTER] key to end the cleaning
process. If left as-is, the ink will harden due to the effects of external light, resulting in nozzle
clogging or other harmful effects.
7
Once the cleaning is complete, press the [ENTER] key.
HEAD MAINT.
[ENT]
COMPLETED
Cleaning LED UV Unit
Periodically clean the ink and dust stuck on the LED UV.
• Be careful not to damage the irradiation part on the bottom of the unit when cleaning the LED UV. If the dirt
or shading on the irradiation part exceeds a certain limit, it may cause binding due to poor curing of the ink.
4
To Next Page
Loading...
