MIMAKI JFX200-2513EX - Page 138

Chapter 4 Maintenance
4-28
1
Select [NOZZLE RECOVERY] of the MAINTENANCE menu.
(1) Press the [FUNCTION] key in LOCAL.
(2) Press to select [MAINTENANCE], and press the [ENTER] key.
(3) Press to select [NOZZLE RECOVERY].
(4) Press the [ENTER] key.
2
Press to select [CHECK BEFORE PRINT], and press the [ENTER] key.
NOZZLE RECOVERY
: CHECK BEFORE PRINT
3
Press to select a setting, and press the [ENTER] key.
• Available settings:
OFF, CONTINUE, STOP
CHECK BEFORE PRINT
: OFF
• OFF:
Do not check before printing.
• CONTINUE:
Check before printing. If recovery is not possible, the following screen is displayed for three
seconds and after that the printing starts.
1200 x 1200 32P Hi Bi
UNRECOVERABLE
• STOP:
Check before printing. If recovery is not possible, print confirmation screen is displayed. Press the
[ENTER] key to print.
1200 x 1200 32P Hi Bi
[ENT]
UNRECOVERABLE
4
Press the [END] key several times to end the operation.
Clear the settings
1
Select [NOZZLE RECOVERY] of the maintenance menu.
(1) Press the [FUNCTION] key in LOCAL.
(2) Press to select [MAINTENANCE], and press the [ENTER] key.
(3) Press to select [NOZZLE RECOVERY].
(4) Press the [ENTER] key.
2
Press to select [CLEAR], and press the [ENTER] key.
NOZZLE RECOVERY
: CLEAR
3
Press to select the nozzle line that needs to be reset, and press the [ENTER] key.
SELECT RESET NOZZLE
: H1-A
H1-A CLEAR?
[ENT]
EXECUTE