MIMAKI JFX200-2513EX - Automatic Maintenance Function Setup

Chapter 4 Maintenance
4-30
Automatic Maintenance Function
To use this machine comfortably, you can set the various maintenance functions to be run automatically.
Here, set performing intervals of various automatic maintenance functions.
Issues such as ink clogging can be avoided by performing automatic maintenance periodically. (Automatic
maintenance function)
For automatic maintenance function, you can make the following settings.
• When maintenance is performed manually, after it is complete and when the time set with the automatic
maintenance function has passed, maintenance starts automatically.
Function name Description
REFRESH The interval between each refresh operation is set.
CLEANING Cleaning type and the interval between each cleaning
operation are set.
• When the message on the right is displayed, the operation set in the automatic maintenance function is not
carried out. Perform the operations of "Disposing of Waste Ink" (P. 4-35) as required.
<LOCAL>
[MNT]
Check waste ink
• When the power button on the front of the machine is turned off, check the waste ink tank
Setting the refresh intervals
An interval is set between each operation of ejecting small amount of ink from the nozzles to prevent nozzle
clogging.
1
Select [AUTO MAINT.] of the MAINTENANCE menu.
(1) Press the [FUNCTION] key in LOCAL.
(2) Press to select [MAINTENANCE], and press the [ENTER] key.
(3) Press to select [AUTO MAINT.].
2
Press the [ENTER] key.
AUTO MAINT.
[ENT]
REFRESH
3
Press the [ENTER] key.
REFRESH
: Lv. 1
4
Press to set the refresh intervals
• Available settings: OFF, Lv.1, Lv.2, Lv.3
REFRESH
: Lv. 2
5
Press the [ENTER] key.
AUTO MAINT.
[ENT]
REFRESH