MIMAKI JFX200-2513EX - UV Level and MAPS Function Settings

Chapter 3 Convenient Usage
3-13
Setting UV LEVEL
Set the UV LED irradiation pattern to be used and illumination intensity to be maintained during printing.
1
Press the [FUNCTION] key in LOCAL.
FUNCTION
[ENT]
VIEW
2
Press to select [SETUP], and press the [ENTER] key.
SETUP
[ENT]
DROP.POScorrect
3
Press to select [UV LEVEL].
SETUP
[ENT]
UV LEVEL
4
Press the [ENTER] key.
UV LEVEL
: HOST
5
Press to select the value to be set.
UV LEVEL
: MANUAL
• HOST:
If this value is set, then both the UV irradiation pattern and UV illumination intensity specified in the
application are used for irradiation.
• MANUAL:
If this value is set, then both the specified pattern and the UV illumination intensity are used for
irradiation.
6
Press the [ENTER] key.
• If you have selected "HOST" in Step 5, then proceed to Step 7. However, if you have selected
"MANUAL" in Step 5, then proceed to Step 8.
7
Press to adjust the illumination intensity (amount of light), and press the [ENTER]
key.
UV LEVEL
0%
LIGHT ADJUST
8
Press to select the ink type to be set, and press the [ENTER] key.
• Available settings:
Color/White/ClearInk
UV LEVEL
: Colored
3