5-11
1
1
1
1
5
Troubleshooting
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Solution
An ink error occurred.
• Check the ink bottle for the supply path
corresponding to the indicated color.
Data was received. • Perform data clear. ( P.2-14)
Message Cause Solution
Ink errors (unusable ink) occur in multi-
ple ink bottles.
Ink supply (print, cleaning, etc.) cannot
be performed.
• Press the key to check the ink
bottle generating the warning.
Replace them with usable ink bottles.
The waste ink tank is full.
• Check the waste ink tank.
The waste ink tank is nearly full.
The waste ink tank is not set. • Set the waste ink tank.
Time to replace the wiper in the capping
station with a new one has come.
(The wiping count has reached the
specified value.)
• Press the key and replace the
wiper with a new one. ( P.4-24)
The data has been received.
• Press the key to perform print-
ing. Or, perform data clear.
Water in the cooling water tank
becomes less.
• Refill cooling water according to P.4-28
“Refilling antifreeze mixed water”.
The LED lamp temperature is high.
• Wait for a while until the temperature low-
ers and the message disappears.
CAN ‘ T OPERATE
I NK ERROR
CAN ‘ T OPERATE
DA T A REMA I N
< LOCA L >
Can’ t PR I NT / CART . [ ENT ]
< LOCA L >
Was t e i nk f u l l
< LOCA L >
Was t e i nk near f u l l
< LOCA L >
Was t e i nk t ank none
< LOCA L >
R e p l a c e a W I P E R [ MN T ]
MAINT.
< LOCA L >
DATA REMA I N
To Next Page
Loading...
