MIMAKI JFX500-2131 - Page 131

Warning / Error Messages
5-17
1
1
1
1
5
Troubleshooting
Message Cause Solution
Ink could not be supplied to the sub
tank.
• Perform “SUB TANK” ( P.5-5) of the
maintenance. Also check the remaining
amount of ink in the ink bottle. Even if you
performed this, when the message is dis-
played, contact your local distributor to
call for service.
Starting of the negative pressure control
has an abnormality.
• Perform “PRESSURE ADJUST” ( P.5-
9) of the maintenance. If you cannot
adjust it to the normal value, or, even if
you perform, it may be displayed, contact
your local distributor to call for service.
The negative pressure cannot be kept
properly
Starting of the positive pressure control
has an abnormality.
The positive pressure cannot be kept
properly.
• Perform “PRESSURE ADJUST” ( P.5-
9) of the maintenance. If you cannot
adjust it to the normal value, or, even if
you perform, it may be displayed, contact
your local distributor to call for service.
There is a slot in which the ink bottle
has not been inserted more than a cer-
tain time.
Set an ink bottle.
The thermistor of a heater is defective.
Turn off the main power to the machine and
turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
A head heater is disconnected.
There was a communication error in the
ink heater relay board.
• Turn off the main power to the machine
and turn it on after a while.
During startup, the following message is
displayed.
Press the key and start ink heater
control.
If the same error message appears again,
contact your local distributor to call for service.
The ink heater thermistor is defective.
• Turn off the main power to the machine
and turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
There remains received data that has
not yet been printed.
Execute the data clear function.
( P.2-14)
ERROR 61b
SUPPLY INK : 12345678
ERROR 6 1 c
NEGAT I VE P . CONTROL
ERROR 61d
NEGAT IVE P.No t Enough
ERROR 61e
NEGAT I VE P . OVER
ERROR 6 1 f
POS I T I VE P . CONTROL
ERROR 620
POSI T IVE P.NotEnough
ERROR 621
POS I T I VE P . OVER
ERROR 627
I NSERT CARTR I DGE
ERROR 702
THERM I S TOR
ERROR 707
! H1 HEATER BREAK
ERROR 714
I NK HEATER COM ERR
I NK HEA TER CONTROL
CANCEL < > START
ERROR 715
I nkHea t erHThr : 123456
ERROR 715
I nkHea t erLThr : 123456
ERROR 902
DATA REMA I N