Warning / Error Messages
5-18
SYSTEM HALT
Message Cause Solution
The ink heater is too hot.
• If the temperature continues to rise,
the print is cancelled and control
becomes impossible.
• Turn off the main power, and wait an hour
or more before turning it back on.
If control became impossible after the
error was displayed, the following mes-
sage is displayed.
Press the key and start ink heater
control.
If the same error message appears again,
contact your local distributor to call for service.
The ink heater is disconnected.
• Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
The thermistor on the ink heater relay
board is defective.
The fuse on the ink heater relay board
was blown.
The fuse on the UV LED Driver board
was blown.
The number of mounted heads is 0
(zero).
• Turn off the main power to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
The ambient temperature is out of the
usable temperature range (too low).
• Adjust the ambient temperature of the
installation place.
The ambient temperature is out of the
usable temperature range (too high).
Message Solution
Turn off the main power to the machine and turn it on after a while.
Check the number and contact your local distributor to call for service.
(“000” is the error
No.)
To Next Page
Loading...
