MIMAKI JFX500-2131 - Indicator; Operation Panel Cable

Names of Parts and Functions
1-7
1
Before Use
3
4
5
6
Indicator
Functions of the Indicator on the top right of this unit are described here.
The indicator has a green and a red lamp.
Operation Panel Cable
You can remove the operation panel from the main body when using this machine.
How to wind operation panel cable
Color of lamp State of lamp State of machine
Green
Lighting REMOTE
Blinking REMOTE (printing)
Off LOCAL
Red
Lighting Error has occurred
Off Normal
• The operation panel is fixed on the main body with a magnet.
• When performing the work, place the operation panel near yourself so that you can push the
emergency button.
• When you remove the operation panel to use this machine, fully be careful about wiring so that the
operation panel cable may not be taken into the belt on the right side of the main body.
• When you use this machine with the operation panel, wind the cable on the hook of the leg at the front
right side of the main body. At this time, check that the cable does not touch the melt on the right side
of the main body.
Put the cable on the
lower hook.
Wind the cable
counterclockwise.
Fix the operation panel on the
main body.
Remove it by pulling
it to the front.
Hook