MIMAKI JFX500-2131 - Chapter 2 Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-4
Setting a Media .............................................2-5
Setting the Media ........................................ 2-5
Check the irradiation position of the
LED UV lamp ................................................2-8
Test Printing ................................................2-10
Test Printing .............................................. 2-11
Head Cleaning ............................................2-12
About head cleaning ..................................2-12
Perform head cleaning depending on the
test printing result ......................................2-12
Printing Data ...............................................2-13
Starting a Printing Operation .....................2-13
Stopping a printing operation halfway ........2-14
Deleting Received Data (Data Clear) ........2-14
Move the Y-bar ..........................................2-15
Chapter 2
Basic Operations