2-13
1
2
Basic Operations
4
5
6
Printing Data
Starting a Printing Operation
1
Setting a Media ( P.2-5)
(1) Open/Close the suction valve adjusting to the media
size.
(2) Press the key to light the VACUUM lamp and
vacuum the media.
2
Press the key in LOCAL.
• The screen changes to REMOTE, and data can be received from the PC.
3
Transmit data to be printed from the PC.
• The printing conditions are displayed.
• For the method of data transmission, see the instruction
manual for the output software.
4
Start printing.
5
Taking out the media after completion of printing
(1) Follow the “Move the Y-bar” ( P.2-15) to evacuate the Y-bar from the table.
(2) Press the key to turn the suction OFF.
(3) Remove the media.
• During printing, media may be heated by the LED UV and raised, causing printing to be interrupted. In
this case, set new media and restart printing.
600x 900 R/MP2
12.Bd.VD/x2 10.0mm
Resolution :
600x900 DPI
Number of passes
Head gap value
Scan direction
Ud : Unidirectional
Bd : Bidirectional
Data type
VD : Variable data
ND : Normal data
Scanning speed
x1 : Standard
speed
x2 : Double
speed
With/ without nozzle
recovery setting
MAPS setting
No display : MAPS OFF
MP1 : MAPS1
MP2 : MAPS2
To Next Page
Loading...
