3-7
1
1
3
Convenient use
5
6
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user
types.
• About default “HOST” function
You can operate this by the setting value specified in RIP software.
When you set to other than “HOST”, it operates by that setting value, not by the instruction from RIP
software.
Depending on RIP software, there are some functions that cannot be instructed by software. In such a
case, it operates by the setting value of “When no instruction from RIP exists”.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value Default
When no instruction
from RIP exists
*1
*1. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority
to the setting value at the machine side, even if you set “Host” to the type registration of this machine.
Outline
FEED COMP. ( P.3-8) -255 to 255 0
Prints the pattern to correct the
feeding amount of the Y bar.
DROP. POS CORRECT
( P.3-10)
-40.0 to 0 to 40.0 0.0
Used to adjust the dot position in go
and return printing.
LOGICAL SEEK
( P.3-12)
HOST / ON / OFF HOST
ON
Sets the scan movable area during
printing.
OVER PRINT ( P.3-27) HOST /1 to 9 HOST
1
Sets the number of layers in which
ink is to be applied.
UV MODE
( P.3-27)
PATTERN
HOST -50%+50% 0% Pattern 2
Designates the UV illumination
pattern during printing.
MANUAL
Pattern1 to 7, NOPRINT
CONTROL
FULL
Sets the light control method for the
UV lamp.
PRINT
Inside/ 0 to 80 mm 30mm
Outside/ 0 to 245 mm 80mm
REFRESH ( P.3-27)
HOST / Lv.0 (Refresh
interval long) to 3
(Refresh interval short)
HOST
Lv.3
Refreshes the print heads during
printing.
WORK CHANGE ( P.3-27) ON/OFF
Sets the operation when printing is
finished.
IONIZER ( P.3-27) ON/OFF
Set the optional ionizer.
VACUUM ( P.3-27)
HOST / STANDARD /
STRONG
HOST
Sets the absorbability of the media.
MAPS
( P.3-19)
OFF/MAPS1/MAPS2 MAPS2
Perform setting to reduce stripes
between passes.
MAPS1
PRINT
SPEED
ADJUST
-50 to +50% 0%
MAPS2
AUTO
MANUAL
PATTERN(1 to 5)/
Smoothing level (AUTO/
5 to 100%)
AUTO
CLEANING
( P.3-24)
OFF, PAGE
OFF
Sets the automatic cleaning
operation for the head performed
before printing.
PAGE
INTERVAL
1 to 1000 page
1
page
TYPE
NORMAL / SOFT /
HARD
SOFT
INTERVAL
WIPING
( P.3-25)
OFF, PAGE, TIME OFF
Sets the wiping operation
performed before printing (when
PAGE is set) and during printing
(when TIME is set).
PAGE
INTERVAL
1 to 100 page 1
page
TIME
INTERVAL
3 to 50 min 3 min
INK
HEATER
Standby
Switchovetr TIM
NONE /0 to 60min
2 min
Sets the time until the head heater
and ink heater change to standby
status.
To Next Page
Loading...
